Bearing fit too loose
  • Has anyone else had a problem with the bearing being too loose in the frame and falling out? If so, how did you correct it?
    Thanks for any help offered.
  • The bearings are a press fitting and they should be securely held, which bearing is the problem and was it loose from the start ?
    In any case, a small amount of normal wood glue on the walls of the hole and then inserting the bearing should solve the problem, the glue sticks to the frame and not the bearing just in case it needs to be removed.
  • Wenn man noch einen schmalen Papierstreifen passender Dicke (vorher probieren!) an die Wand der Bohrung leimt und das Lager in das noch feuchte Bett einpresst, besteht weniger Gefahr, dass überschüssiger Leim an das Kugellager geraten kann und dort Probleme macht.